View Full Version : Another Tire-Wheel question
11-02-2011, 02:27 PM
I just bought a T100 and would like to switch out the 15 inch wheels for 16. I have some aluminum GMC wheels sitting around and would like to run some 235/85 16's. Is this going to work. I guess I am being lazy and not wanting to dig them out of storage to check back spacing. Thanks
11-03-2011, 01:18 AM
You'd probably find more answers on Tundra Solutions. I'm Not sure if they have T100 section however.
11-03-2011, 03:24 PM
No, the GMC wheel will not fit the T100. The inner wheel hole is the wrong diameter. The tire will work fine on a different set of wheels. Well, I should say that. The wheels might work if they are pre IFS GMC half ton wheels.
11-04-2011, 02:15 PM
NO,You can go here to select.It seems there is that wheel.
Thanks for the answer. It saves me digging them out to try them. I should get them out to sell and then buy some 16's for the T.
11-04-2011, 05:13 PM
The wheel bolt pattern is the same (6x5.5). Not sure of the hub size, though. But I've seen a few Toyotas running around with GMC wheels, and seems to work for them (although it is blasphemy :D). But Tacoma, 4Runner wheels can be had fr cheap, so that's the route I'd go. Just make sure to NOT get 05+ Tacoma and 03+ 4Runner wheels, as they've got a higher offset.
11-07-2011, 04:10 AM
I am running 16" Tundra wheels on my truck with 285/75/16 tires and only have a bit of rubbing on the front when turning and the suspension compressed.
11-08-2011, 01:38 AM
Thanks again for the comments. I just bought some 16's off of a Tundra from neighbor. I am planning on putting some 235/85-16's on it with no lift. What little I have found it should work w/o rubbing.
Powered by vBulletin® Version 4.1.11 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.