Roof repair Skamper 60S
Ok, here's what I did on my roof repair on the rear corners of the Skamper 60S.
Skamper used the Herco torsion roof lift, the torsion bars tie into the rear corners on the roof. The plywood carries the torsion load and over time warps the corners.
Once the corners get...
M101A3 with Popup camper
I installed a Skamper 60S popup camper on a M101A3. The campers C/G lined up with the trailer C/G. I've pulled this off road in Baja and California with no problems.
Roof repair
The the rear herco torsion bar has ripped out of the corner. I installer an angle iron bar between the two rear corners and spliced a replacement corner. See pictures below.
M101A3 Trailer with Skamper 60S camper
Ok So I got a deal on a 1995 Skamper 60S needed a few repairs but still a deal.
Not having a truck I needed a way to transport the camper, so I picked up a M101A3 trailer.
CG matched the camper and at 869 pounds still had margin to add more payload.
So...
M101A3 Trailer with Skamper 60S camper
I Installed a Skamper 60S on a M101A3 trailer, (see picture). I've done a couple of camping trips and one off road trip to
baja. It's been a great camper. It takes 15 mins to setup and take down. when not in use it fits in the driveway with room to spare.
I installed a 1995 Skamper 60S on a M101A3 trailer (See picture). Before I purchased the camper I made sure the center of gravity (CG) matched the CG of the trailer.
The extra storage in front is perfect for fire wood, spare tire and extra water. I've upgraded to a solar panel to charge the...
M101A# with a pop up camper
I have a Skamper 60S installed on a M101A3. It works well and I have done a lot of off roading with this setup.
It has lots of storage in the front and on the sides. Added a solar panel to charge the battery.
Adding a front tool box for the battery and locked food...
I have a 1995 Skamper 60S mounted on a M101A3 3/4 ton trailer. Took it to Baja and did a lot of off road driving.
So far I'm happy, still have some mod's to finish but camping comes first.