Recent content by Cummins_expo

simplicity - Power pack ( as long as you can integrate with you build ) Not all power packs are created equal. If you don't mind plugs and wires going everywhere by using the power packs provided "outputs" Bluetti used to have a 30 amp DC plug that was perfect for wiring up to a fuse...

price? location?

Great looking rig- Not to hijack the thread, but we have found a marine bilge pump heater to be an effective solution to keep the battery compartment area warm enough to stop BMS cold weather issues. A small 400-watt on at 40* off at 50* consumed less power then the self-heating batteries...

I think you're biggest challenge will be the ability to have a charging system capable of replenishing your power banks in the winter time. Low light, cloudy, snow potential. We have a rig here with a 15kw 48v system, the owner wanted All electric. Here's what we have observed over the...

You could pick your flavor of E350 Cutaway and have a modern composite body built and end up with similar results but better in many respects, then have Ujoint convert it to 4x4. Most of your off-the-shelf box vans are built with a wood/FRP wall and steel floors. Many are mass-produced by...

My guess is the use of composites in construction

One of my all time favorite builds - Good luck on the sale and with "stick n brick" life in Colorado

Unless you mean pass through to cab. That is open with a little sliding door

Hey Zip yes has the 5.4 Technically yes a pass through with a little modification

This doesn't belong to me but I can put you in touch with the seller- We did build it for him and can answer any questions. Van is located at our workshop in Prescott AZ, owner is located in Alaska. https://prescott.craigslist.org/cto/d/prescott-2014-mini-box-truck-camper-e350/7822649938.html

How a van should be properly used ! Good luck with the sale

I have the top section of the wedge ModCap and Yes it has a pass-through. We are playing with it at the shop to see if it could be used as a poptop option for Econolines. Alucab makes some BEAUTIFUL stuff and can't wait for the family version

I was fresh out of Boot Camp with money to burn. Grabbed a local Thrifty Nickle and found what I thought was the deal of the century. 77 cj7 with a small block 350, Super Swampers, and a 4" lift. All this for $1,000.00, Grabbed a ride with one of my buddies to Salida CO. Arrived at the...

You might been a prybar- mine was glued down along with bolts through the back to a thick plate for the seatbelts

I couldn't tell you as I have limited knowledge of these. I would call JDM Offroad in Everette WA.- Brian is the man in Canters and Importing them from Japan. He also maintains a few canters in stock- Tell him Jim 365Camper sent you if you do