Iain_U1250's latest activity
-
This was about 10 degrees with a small amount of inertia. Interestingly, when getting it out slowly with no inertia it sat at an angle... -
I agree 100% with dynamic vs static comments (dynamic = “inertia”). Which is one reason why I have seemed to be obsessed over the years...
-
That was 25° when the sand let go with quite some strains in the drivers underwear. We ended up securing the vehicle with two winches...
-
Iain_U1250 replied to the thread Lean angle, Roll..On ours Unimog U1250, we have recently gone over 35 degrees, but the was turning at the bottom of a dune on an entrance to the beach and...
-
-
Iain_U1250 reacted to whomisi's post in the thread Unicorn on the Ocean - 1120AF Coming to Canada with
Like.
Slowly slowly slowly, Chassis painted, after much degreasing. Am glad there wasn't any rust to be found though, I guess I have the... -
Iain_U1250 replied to the thread Unimogadventures - Our build and travel thread.In addition, I have refurbed the back axle, with new diff lock seals, new seal in the torque tube and new bearings and seals in the...
-
-
Iain_U1250 replied to the thread Unimogadventures - Our build and travel thread.Finished my new exhaust, 4" from front to rear. It is quite a tight fit, so I have added a lot of extra hangers to stop it moving...
-
-
Lowly Update: More 3D printed goodies. Above the passthru between the habitat and cab is the location where air and electricity is run...
-
Iain_U1250 replied to the thread Introduction, Tuning/Uprating Story And How I Got here.Hi, not offense taken, all good discussions are great. I have official Bosch technical manual for the inline fuel pumps, it covers...
-
-
Iain_U1250 replied to the thread Unimogadventures - Our build and travel thread.A bit of an update. Since the rear axle is off, and I am still waiting for some seals, I'm doing a lot more of the other things on the...
-
-
Iain_U1250 replied to the thread Introduction, Tuning/Uprating Story And How I Got here.Hi, welcome to the forum, I've been down the "more power and speed" road, and settled down to around 200hp, up a bit from the original...
-
Iain_U1250 reacted to Tonka_Truck's post in the thread Introduction, Tuning/Uprating Story And How I Got here with Like.
Hello everybody, I'm Daan, from the Netherlands. I originally registered here to ask if anybody here knew if a LDA (the turbo membrane...
