jscherb's latest activity

The rack in the previous post adapted to my JKU. What if... Or on the LJ: Wouldn't be hard to make one of these.

Need to carry more fuel? I've posted about the front fender jerry can mounts before in this thread, but I hadn't seen anything like...

For all the years I've had these bags on the back of my JKU and LJ I've taken them through the car wash - either the self-wash, where I...

Now that the plow is off the and the LJ is a daily driver again, I towed my trailer to the new house today; I've been moving a lot of...

Yes, back when I was building the initial top I made up a rear window with a defroster grid, but I decided to try the Jeep for the first...

I removed the plow from the LJ this morning, I won't be needing it anymore. Where I'm moving to there's a bit less snow and lot less...

Agreed. My calculations for 2-gauge copper were to provide 14.4 volts at 20 amps to the battery at the back of the Jeep, supplied by...

Dan, Thanks, I have looked at that one. I like that it has a 50amp charge rate and handles solar as well. It's something I'll...

Haven't moved yet. We took possession of the house in mid-January and since then I've been spending about half time there doing...

I'm happy to provide any more details about the installations in my Jeeps or try to answer any other questions you might have.

The time it takes to fully charge the battery is a function of the voltage and the current input to the charge controller and the output...

Thanks for the kind words. The tray holding the battery (or can hold an ammo can) and the MOLLE grid below it is something I designed...

I should spend a little time on what this battery is not - it's not intended to be the primary starting battery - the maximum...

So while I'm deciding if I want to make those electrical upgrades to my system (2ga copper wires, DC-DC lithium charge controller...

Now to figure out how to charge the lithium battery with the alternator... The wiring from my starting battery back to my house...