Dude, you're just trolling at this point. Take your 4Runner and go have fun with it until you can afford an upgrade.
If you won the lottery tomorrow... your 4Runner would be in a used car lot as you drove off in a LC. This whole ridiculous thread has been in reality about economics. If...
I sold my 15 RR Sport after 6 months and went back to LC. Previously, I had a 2008 LC prior. LC all the way... not even close, especially with the new interior of the LC. Just my 2 cents. = D
FOUR PAIRS of legs (total of 8) for my G550, but ended up going in a different direction. Practically brand new with stainless hardware. Were used for my Alu-Cab RTT for half a season and then taken off after going with a full roof rack from FR.
Will fit just about any truck with gutter...
Found out from Rin today that I installed the front mount incorrectly lol. Apparently, you are supposed to put one of the front mount bolts through a slat. I've attached a pic. Weird that they didn't make the front mount wide enough to bolt through two slats instead of just one.
Little update on the Alu-Cab shadow awning install on my Frontrunner roof rack. After about a week I noticed some loud and consistent squeaking from two slats that were to the left and right of the front awning mount.
Due to the way Frontrunner slats are are mounted (via a bolt from the...
It has a single dropdown, but it doesn't need it unless its in 20 MPH+ winds. I actually added the awning room since these pictures, that adds two more legs to support the weight of the canvas. Brackets are pretty solid.
Got the awning installed. Also added the two extra legs for the sidewall kit while at it. Dang, pretty heavy now! Thanks Tom@ Adventure Ready for spending part of your Sunday helping me get this up and running.
Almost forgot, I replaced the four long bolts with Grade 10 bolts and Grade 8...
Will post some more pics when it's all put together this weekend. The bolts on the long leg are about 4 inches long and go all the way through the rack via 2 drilled holes. i sort of messed up the 1st one by trying to do a small hole and then expanding it. The 2nd hole I just drilled with a...