Recent content by pikdiesel

Here is both links to the videos I made that follows my trailer/RTT build. https://www.youtube.com/watch?v=xfEJ4NbiEIQ https://www.youtube.com/watch?v=_8gy4ZWpS38

Gonna try to make it to Butler and York this year!!

Well, it has been a year since posting. I have been able to use me trailer and tent set up with much success. I ended up mounting my lid like the few have shown. The height of the rack/tent was dependent on the function of the annex/changing room. I wanted to be able to stand up while...

I love my set up of RTT on my homemade trailer. I can set up camp and forget about it. It is not difficult to setup/take down tent, but the annex room can take some time to get properly set up. I don't know if you have tented on the ground much, but there is a huge difference being off the...

Thanks for the compliments guys. It took me 2 months to get the trailer done. So far, it's working great. It pulls down the road without a wander and the CVT is awesome. Looking forward to getting out in it this fall. :wings:

Here's my 2007 Jeep JKU Rubicon and homemade trailer topped with a Mt. Hood CVT All packed up and ready to go! Camp is set!

You will not be disappointed! I am a recent CVT owner and can echo all of the praises that this company is getting. Their customer service is second to none, just like their tents! I recommend CVT to everyone that walks over to look at my tent!

It has been awhile since I posted any progress...well here it is! Recieved my CVT and it is mounted on my homemade trailer. I am very pleased with how my set up is working. I did start with the tent at a lower height; just enought room to access the trailer 'bed' with the tent on. I come...

Here is what I have... thinking of making a flat lid with hinges that open from the side. Thanks for the suggestions.

I plan on getting a CVT to run on my trailer. I also would like to run a hard lid/top to keep things water tight. I have seen plenty of pictures with RTT directly attatched to the rack which is hard mounted to the top/lid. For those who run this set up, how is it getting into/opening the...

2 inch square tube for frame and 1 1/2 rails Measured so that it is a full 4ft x 6ft inside mounting 1750 lb springs weld in spindles; running stock JK wheels with 1.5 inch spacers and it's a roller!! I plan on making the front corner panels hinge open/close like a door; that's why...

Thanks for the input guys...anyone else have opinions?

Hey guys, I'm in the middle of a trailer build and I'm to the point of making it a true roller! I would like to get some input on how long to make the tongue. The trailer is 4x6 in size and I plan on leaving room for extra storage on front of the bed. How long, from hitch to the first...