Pilot the angle before mate all PVCs
The system is holding at least 3 gallons, enough for quick showers 2 or 3 and washing dishes etc.
My plan is to build the system that allow me to add expansion tank in the future.
Sent from my iPhone using Tapatalk Pro
Installing valves
Sealed
I mess up the positioning of the faucet [emoji38] oh well it’s going to be pressurized anyway, shouldn’t impacting the water flow too at all.
Pressure gauge, I’m planning to have the pressure at 40 PSI.
Sent from my iPhone using Tapatalk Pro
Finally got the ladder!
Unboxing
Installed
Done!!
I really like it, very sturdy and it is a lot easier for me to get up there.
I’m a big guy and trying to pull myself up on the tire isn’t the best option. This is one of my favorite mods so far.
Sent from my iPhone using Tapatalk Pro
Set up less than 2 minutes, but for the windy day you NEED to stake it; otherwise the wind could blow your awning and snap it.
Sent from my iPhone using Tapatalk Pro
I always wanted an awning, after did some researches and comparison to ARB and others; I decided to go with Rhino Batwing.
Mounting to the Roof Basket
Love it!!
Sent from my iPhone using Tapatalk Pro
It has been awhile since updated.
Upper Ball Joint replacement.
Pop it out
Use the ball joint spreader that I rented from AutoZone
Ewwwww
New ball joint, and greased up!!
Done!!!!
Sent from my iPhone using Tapatalk Pro
Let’s just take a breather and I think no one is in the wrong here.
I had been active in this forum going into 4 years, and a build thread with many people asking all kind of questions.
99% of the people in Mitsubishi section are bunch of nice folks, and had been nothing but helpful and...