tongue weight is good now that I added the batteries and extended the tongue by a bit. I was worried about that when I extended the rear 1.5' but it came out okay. Ideally I would have liked to move the axle back some but it still came out okay.
This shows the back kitchen area without the bulkhead. This will soon be closed off to separate the sleeping area from the back (kitchen area).
I got a 6k btu window unit setup inside as well as the walls carpeted for some extra insulation and noise barrier.
A shelf with some 12v charging...
Once the walls were up, I started out insulating everything with 1" foam. I left window openings for installing some prefabbed windows later on.
Once I got all the insulation in place I did some initial wiring since the next step was the exterior sheeting. Once this was done I took the...
Once I got the bracing and framing like I wanted it was time to sand and paint. Here's some shots of the trailer behind the 4runner and from above.
After a ton of sanding I was left with this. Shortly thereafter, I set out to paint the whole thing with something to keep the rust down while...
This build started off as more of an expo build. I wanted something that I could keep the RTT off my truck while on the trails. So I started out by ordering tons of parts that I thought I might need. I went with 6x5.5 hubs to match my toyota lug pattern in case I needed a tire off the trailer in...
your early build encouraged me to try something on my own. I still say I'm going to buy the plans from your first build and try that. I'm working on a build thread for mine now. and following this on youtube, i get excited everytime i get a notification of a new video. nice work as always!