Recent content by uhkhu

  1. U

    *SOLD* 2021 Ram 2500 6.4 Hemi, 16k mi, w/ FWC Hawk Woolrich Flatbed & MITS Tray

    What gearing are you running to crank those 37s? How's your gas mileage?
  2. U

    2019 Ford F-350 w/ 4-Wheel Camper Grandby on Norweld Flatbed, fully built turnkey truck, LOTS of upgrades

    Is that the standard silver spur counter? It looks more black and less marbled.
  3. U

    Hey not sure if you're still active here, but I had a couple of questions about your old flatbed...

    Hey not sure if you're still active here, but I had a couple of questions about your old flatbed rig. I'm building something very similar and have been trying to figure out tire sizing. I saw you went with 37s, which I'm considering. What was the gearing on your truck? Any regrets? What gas...
  4. U

    **SOLD** 2017 Earthcruiser GZL 300 (2019 ZR2 Bison potentially available)

    $32,000 for the camper. Located in Bend, Oregon Selling my 2017 GZL 300 slide-in camper. Earthcruiser no longer makes the GZL so these are very hard to find. This is a great rugged rig that is very capable of getting off-road and into some pretty remote areas not easily accessible with larger...
  5. U

    How to make a cheap isolated dual-battery setup for $50

    Right now I'm putting in a small 20Ah AGM to power a 12v outlet and usb ports in the bed, but I'd like the ability to upsize in the future (probably not larger than 50ah ever). I followed the original post and went for 4ga wire and 80A fuses for each battery. Are these overkill? What dictates...
  6. U

    How to make a cheap isolated dual-battery setup for $50

    Is there any need for a charge controller on the second battery? I'm installing the original basic configuration with a 20Ah AGM secondary. Is there risk of overcharging this if it's installed as shown on the first page of this thread?
  7. U

    How to make a cheap isolated dual-battery setup for $50

    Does the solenoid only see load from the connected equipment when the truck is running (when engaged)? If I'm running a small compressor (20A) from the second battery while the truck is off, does that current even reach the solenoid?
  8. U

    How to make a cheap isolated dual-battery setup for $50

    Excuse my electrical incompetence, but what determines the size of the solenoid? The original post showed an 80A and it was later changed to 200A for adding a winch. Is that to run a winch while the vehicle is off? I'm just looking to have a small 20Ah battery to power some lights and charge...
Top