Search results

Good looking truck. Is that the 2.5” or 4.5” Carli to fit the 37s?

OP, what kit did you end up going with?

Sounds like it’ll hold the weight. How about a single crossbar on the cab near the B pillar with a Yakima or similar fairing?

Internet high five!

Tire size - what about 255/80-17? BFG KM2's are 33.3", E load rating, and will fit the 7.5" rim a little better than 285's.

How about this cheap folder from Home Depot? Same construction as your current setup, but half the space.

Down to $2200 now

Read through the smb thread just now, and the hot dog looks great! Way to go Sweez and MG!

Sweezy, got a build thread for the V10?

http://jacksonville.craigslist.org/cto/5670929811.html 2001 7.3, solid axle swap, no transfer case or driveshaft. Seems like a third of the way to a UJ swap

Welcome fellow ADVer! Love the XR plate.

^^ HeyDuke approved for sure! Not sure if this one is approved though.. http://www.ebay.com/itm/2010-Ford-E-350-4x4-van-lifted-Quigley-4wd-custom-V10-original-owner-Econoline-/152131094062

Whose swivels are these?

1st question: Any idea what windows he has in the doors and back? I'm eyeballin' a V10 RB cargo real hard, and it's all sheet metal. 2nd question: When using a tuner on the V10, does it stay in the OBD2 port, or can I remove it to plug in a ScanGuage? What tuners/tunes do you prefer? The wife...

Is a hydraulic handbrake and locked diff enough cowbell for you?!

At 6:00 in your video you talk about tire rub on the fender flare under compression, showing the 2"ish clearance between the tire and flare, and mention rearward axle growth as it compresses. How much clearance do you have in front of the tire? I ask because when I replaced the rear suspension...

Stumbled on this beauty while searching for ideas. Looks like the Danny DeVito twin to V4's Arnold! El Camino

Too damn cool! :Wow1: I'm researching now, hopefully shopping in the near future, and when (not if) I build my UJOR swap, this would be a serious contender on the mods list. Is the clutch you mentioned in post#9 (http://secure.chassisshop.com/partdetail/272-S-3-4/) the one that you built...