Search results

I'm finally at the point where I need driveshafts for my conversion. I'm going to a NP271 case. What flange yoke do I need connect the driveshaft to the transfer case? Do I just need to get my stock rear shaft shortened? I see on the u-joint website it says that I'll need a whole new shaft, is...

I'm in the process of overhauling a used 4r100 for my 4wd conversion. The ATSG manual says I should have 8 check balls under the the valve body gasket. I have found 9 check balls as shown below. The extra ball is the furthest to the right in the pictures below. I think the ball of interest...

I have a Weldtec “Grocery Getter” 6 inch lift for sale. This is labeled as the 6” baja grocery getter on their website. This lift was used for approximately 18 months on a 2001 e350 7.3l and has about 5,000 miles on it. It is still assembled so you could technically just weld on the flanges...

I have a Weldtec “Grocery Getter” 6 inch lift for sale. This is labeled as the 6” baja grocery getter on their website. This lift was used for approximately 18 months on a 2001 e350 7.3l and has about 5,000 miles on it. It is still assembled so you could technically just weld on the flanges...