Search results

what are the two circular dials btw?

Very nice! I see you also relocated the temp sensor? Does it work better over there than by the door?

very easy to do ... I had to extend the thin power wires a bit, but that was trivial ... the other 'phone jack' control wire is really long ... and you can route it alongside the heat ducts behind the cabinet.... I used an oscillating saw to cut out a square of wood in the panel ... and managed...

Life is so much easier after I relocated my Truma control panel ;)

yeah super cold that one night - I think I'm going to winterize the thing .. don't want to risk cracking my water lines... I can do without the luxury of running water ... my two 5 gal jerry cans of water should be plenty. I got a propane tank heating blanket but that's going to hog battery...

So I'm full-time in my D13 and a bit of a noob when it comes to Dwelling. When I first got my rig back in April, I immediately took it to Moab & Valley of The Gods UT for a 2 month 'Desert Test' - learned a lot. Now I'm doing a 'Winter Test' up at Lake Tahoe CA - seeing how far I get until...

So I'm full-time in my D13 and a bit of a noob when it comes to Dwelling. When I first got my rig back in April, I immediately took it to Moab & Valley of The Gods UT for a 2 month 'Desert Test' - learned a lot. Now I'm doing a 'Winter Test' up at Lake Tahoe CA - seeing how far I get until...

I'm not suggesting anything .. just reporting my experience (and solution) in case anyone else runs into it ... I'm not the only one to experience this either - it's a known thing .. not sure it's a common thing though ... That there may be other issues in my trailer I have absolutely no doubt...

Hey I'm just reporting my experience as it happened to me - Hey I'm just reporting my experience ... maybe you are lucky with the tank switches but I certainly was not . These self priming pumps are only rated for a certain distance between pump and source ... so the distance between front/rear...

The three-way valve kit is here: https://a.co/d/88fVjcw fittings/pex can be found at http://freshwatersystems.com

Another Important thing I learned the hard way .... My D13 has a front and rear tank for water. Front meaning closest to the hitch I had both filled up and shot off to the amazing deserts of Moab Eventually my Front tank went empty. Ok I thought .. so just use that lever under the bed to switch...

what the heck is 'fingernail polish'? What aisle at Home Depot? :)

Batteries were 'drop-in' .. and then you have to re-program the Renogy Inverter ... which was pretty simple ... ROA had a blog post about the exact settings: https://www.rvsofamerica.com/lithium-battery-configuration-renogy-pcl-inverter-charger/ The batteries I used: https://a.co/d/gtN4vPj

Top Tip - there was a handy remote control taped to my HB9000 unit .. with way more functionality than the little panel down near the floor .. go hunt for your remote! :)

I did 3 LiTime 100Ah batteries (with BT connectivity) - they fitted great .. a bit smaller (and MUCH lighter) than the AGM's it came with ... never looked back .. SO MUCH BETTER ....

Top tip - as you can see in this picture, I **************** my ARK 500 jockey wheel ... apparently I wound it out too far - there is a difficult-to-see engraved line on the tube that you shouldn't extend past ... lucky for me the good folks at ARK sent me a replacement :)

First weeks .. new trailer D13 from ROA ... Valley Of Gods .....

All of these horrible stories about OBI and warranties .. I'm SO glad I got mine from ROA .. they do their best for their customers ... above and beyond actually ... and their support is TOP NOTCH ....

Has anyone had any luck getting the AC to cool down more than a few degrees? I'm sitting out here in the NV desert .. its 120 outside ... I'm on shore power 30A .. with AC set to 64 desired ... the HB9000 can't seem to get the trailer below 88 .. some cold air is coming out of the vents but not...

found em... they are Neofit quick connectors and can be sourced from https://www.freshwatersystems.com/