Thanks! The tongue is 64" from front edge of the frame to the tip of the receiver. It is 88" all the way back to the front crossmember.Looks good, what's the length of the tongue?
I had planned on 2x3 but like the 2.5" you used
The piece on the end is a hitch extension.Caster came out nice.
Looks like you butt welded a pre-fabbed 2" receiver section (2.5"x2.5"x3/16) to the end of the 2.5"x2.5"x1/8" draw bar. i know its too late, but why didnt you use 3/16 wall tubing for then entire draw bar? Would just need to drill a hole and add a collar for a one piece complete draw bar.
Thanks! The tongue is 64" from front edge of the frame to the tip of the receiver. It is 88" all the way back to the front crossmember.
I always liked the symmetry of the 2.5". That's really the main reason I went that route.
I don't think you can lose either way.