# 6
(above) After finishing the under-seat work, it's time to pre-wire the rear cabin...First up, install a shore power inlet...It might be handy if you are camped out with access to 110 volt AC...Maybe for a heater or a microwave or something power hungry like that...
(above) Installed ground prong up...It's how it's done in hospitals and Alex works in a place like that...Keep it familiar I say...
(above) Inside it looks like this...
(above) Pre-wire for LED lighting...This took a lot of time pulling all the wires over, under sideways and down...
(above) Curb side 12 volt DC pre-wiring...
(above) Driver side tangle...Each and every wire end was stripped, soldered, taped and/or heat shrunk, then metal taped out of sight...Count the wires...Yeah, it took a while...
(above) On the driver side is one area that has a high chafe potential...To remediate that, the wire bundle gets protected as you see...Next it's put in position and taped in place...
(above) Everything connected tight and right, then taped out of the way...The tape is metal fireplace duct tape...Good stuff...
(above) The plan is to have red LED rope light at the front and rear ceiling cross bars and to have white LED rope light at the next two inboard cross beams and at both the driver and curb side side rails near the roof / wall seam...
(above) Another day done, and it was a long one, but I'm stoked how it's turning out...