Page 48 of 48 FirstFirst ... 38464748

Thread: Box Rocket 1995 FZJ80 Build

  1. #471
    Join Date
    Jul 2006
    Location
    Utah....where else?
    Posts
    3,175
    Quote Originally Posted by Silverhorse View Post
    educate me on HAM vs. CB
    I'm no expert and there are many more knowledgeable that me on this subject. In fact, there's a whole section of the forum dedicated to communications that will have loads of info.
    But the short answer is that HAM has far better range than CB and operates on different frequencies. They are both amateur radios but an FCC license is required for HAM use. CB's are becoming less and less common and more and more people are using HAM. But for me, it's mainly because the trips we do are either very spread out from the group, or we travel solo and need improved range. Also, it's what we use for our race truck and chase vehicles so it will be a needed piece of equipment for my 80 to work as a chase vehicle.
    Adam Tolman
    '95 FZJ80
    '08 Off-road Trailer
    TEPUI TENTS. 10% OFF Forum Member Discount

  2. #472
    Join Date
    Mar 2015
    Location
    New Hampshire
    Posts
    558
    Hey Box Rocket,

    Did you have to trim your fender flares at all with 35s and the Slinky setup? I'm in the middle of deciding whether to put flares back on my rig or fill in the holes...

  3. #473
    Join Date
    Jul 2006
    Location
    Utah....where else?
    Posts
    3,175
    Quote Originally Posted by lumpskie View Post
    Hey Box Rocket,

    Did you have to trim your fender flares at all with 35s and the Slinky setup? I'm in the middle of deciding whether to put flares back on my rig or fill in the holes...
    No flare trimming. Little pinch weld hammering and mud flap trimming.
    Adam Tolman
    '95 FZJ80
    '08 Off-road Trailer
    TEPUI TENTS. 10% OFF Forum Member Discount

  4. #474
    Join Date
    Jul 2006
    Location
    Utah....where else?
    Posts
    3,175
    May has been busy. It started out with a trip that's been in the works for several months. The guys from Autocraft in Australia that make the Slinky kits and Redline Land Cruisers (their US Distributor) wanted to do an "overland" style trip and asked me to help with the route. It was essentially a "Utah Traverse" that some others have done but we added some extras. We started in St George, UT and went south to Toroweap on the North Rim of the Grand Canyon. Then we went east and camped near Lake Powell and made our way further east (and north) to finally end in Moab 3 days later just in time for Cruise Moab. It was a fantastic trip! Part of the goal of the trip was to do some product testing on the Slinky products. That was a huge success.
    .
    At the beginning of the trip before we left, I made the switch from the Stage 1 shocks on my Slinky kit to the Stage 4's. The stage 4's are remote reservoir 2.5" shocks with internal bump zones and Compression Dampening Control (CDC) for full adjustability depending on load and terrain. I'll be writing a review on these for TCT Magazine but I will say that these are awesome shocks! We were regularly at speeds above 70mph on the twisty dirt roads and through whoops and washboards with full loads and RTT's. Good stuff.
    I was glad to have the use of the two-post lift at the IH8MUD HQ to swap the shocks. Made it much easier than trying to swap them in a parking lot.

    .
    A few shots from the trip

    .

    .

    .

    .

    .

    .


    .

    .

    .

    .
    The rear shocks use a piggyback reservoir instead of a remote reservoir for ease of fitment.

    .
    Adam Tolman
    '95 FZJ80
    '08 Off-road Trailer
    TEPUI TENTS. 10% OFF Forum Member Discount

  5. #475
    Join Date
    Mar 2011
    Location
    Houston, Texas
    Posts
    91
    As usual, great pictures.

  6. #476
    Join Date
    Jul 2010
    Location
    SoCal
    Posts
    322
    Nice upgrades. I was wondering why we didn't see you at the OE West. Can't wait to see the write up on the testing.

Page 48 of 48 FirstFirst ... 38464748

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •