Rotopax Water Pack mounted to the M-PAC from Springtail Solutions. Same plastic spout and same metal vent I used on the previous Rubican and Rotopax.
This was done on the M-PAC but same could be done on the FrontRunner or Trailgater into the wood sliding table, it would need to be vented differently on those.
These are all so I have water where it is convenient. Springtail rates their table at 40 lbs load. Rafting I always planned for a gallon a day so I have a 4.5 day water setup with these.
ETA: The Rubican could be mounted to the M-PAC without an issue.
Mounting a Rubican to the Frontrunner , or Trailgater could be done but the spout would be hard to get to and the vent would need to be worked out. The rotopax with the plastic spout I can test out for the vent on the Frontrunner if there is an interest..
I have the Frontrunner table so may try it out, The Springtail worked out better for me in the end.
This was done on the M-PAC but same could be done on the FrontRunner or Trailgater into the wood sliding table, it would need to be vented differently on those.
These are all so I have water where it is convenient. Springtail rates their table at 40 lbs load. Rafting I always planned for a gallon a day so I have a 4.5 day water setup with these.
ETA: The Rubican could be mounted to the M-PAC without an issue.
Mounting a Rubican to the Frontrunner , or Trailgater could be done but the spout would be hard to get to and the vent would need to be worked out. The rotopax with the plastic spout I can test out for the vent on the Frontrunner if there is an interest..
I have the Frontrunner table so may try it out, The Springtail worked out better for me in the end.
Last edited: