Superduty
Adventurer
Looking for ideas to secure an ARB fridge to a flat plywood pullout. Basically, I have built a pullout on drawer slides. The pullout is a flat sheet of plywood. The ARB tie down straps attach to an upright at the front and rear of the ARB metal slide. I suppose I could bolt those tabs on the ARB tie down straps directly to the plywood, but it looks like they were designed to bolt up so they are in a vertical position.
I've read that you can bolt directly into the bottom of the ARB fridge. I am not sure that is the best solution in a vehicle where the fridge will get bounced around a lot. I think it will also be nice and easier to remove and reinstall the fridge if some sort of strap system is used.
TIA
Jack
I've read that you can bolt directly into the bottom of the ARB fridge. I am not sure that is the best solution in a vehicle where the fridge will get bounced around a lot. I think it will also be nice and easier to remove and reinstall the fridge if some sort of strap system is used.
TIA
Jack