If you running a 15" wheel you have a pre 08 van which is gong to be really hard to get 33" tires with the fenders and bumper still on it. Then you are going to need to find a E rated tire in a 15" wheel in a 33" prob not going to happen.
Jaweezy has a 08 and newer van? that is really a 250/350 8 lug so it already sits higher then the earlier models.
How about a pic of stock wheels and tires on a 6" lift.
I dont have any pics of what your asking for but here is how much we had to trim this bumper to run 33" tires and it has our 6" Baja Grocery Getter lift kit.
Good luck on your project, let us know if you need parts.
As long as you have the same 5 holes on 5.5" you could use any other rim size (check back-space). This was my e-150 on Moog 880 springs and HD rear leaves. 265/70/17 wheels
View attachment 430134
How many inches of lift did the springs net you?
May be a couple over the worn out springs. It should be 1 or 1.5” over a spring in decent shape. I was able to correct the camber with adjustable cams. Alignment is the may issue with lifting to the point that you need something like the Weldtec kit.
It is a 350. There are guys with 250s and 350s fitting 33s with only a 2" Moog spring lift. Uhauler is one of them that I can think of off the top of my head.Did your van start as an E350?
Only if they don't fit.33s with a 2" lift sounds like a headache.
FROADER,
Did your van start as an E350?
Could you measure from the center of your hubs straight up to the fender for me?
I'm trying to figure out how much lift my van has.
Thanks a lot if you can.