'round n' back again
Explorer
gen 2 r.h. axle onto gen one inner axle.
bolts misaligned by roughly2mm.
common problem?
i just have not heard about?
my solution is to remove inner axle and rotate outer axle cup and bore new holes.
is there a better solution?
ive had actually quite a few little issues like this on the swap ive tried to document them best possible.
the alignment yet to come. due to the ignoramuses at les schwab im not sure we will get to where we want to be on alignment either.
bolts misaligned by roughly2mm.
common problem?
i just have not heard about?
my solution is to remove inner axle and rotate outer axle cup and bore new holes.
is there a better solution?
ive had actually quite a few little issues like this on the swap ive tried to document them best possible.
the alignment yet to come. due to the ignoramuses at les schwab im not sure we will get to where we want to be on alignment either.