1st gen bumper width?

[mwaltd]

Looking for the width of front bumper and frame rail width for 1st gen montero/raider. Could be stock or ARB, selling my comanche to buy a raider. And if the width is close I plan to keep the ARB from the comanche to fit to the raider

 

[yugo308guy]

I should be able to check tonight after work. My front bumper end caps are cut off though, do you just need the measurement of the chrome cover end to end, or do you need the end caps included in the measurement?

 

[mwaltd]

the chrome section would be fine, or if you could get measurment front outsidse of fender to outside of fender would be great too and much appreciated

 

[yugo308guy]

OK....the frame rail width from outside to outside is 3 3/8". The chrome bumper cover is 55" with an additional 4" on each side to reach the outside of the fenders, equaling a total of 63" outside fender to outside fender. Keep in mind the this measurement is just below the turn signals, and as you move further towards the rear of the fender it starts to flare outwards a bit, making the measurement a bit longer. Let me know if you need more specific measurements.

 

[mwaltd]

That's perfect. Thanks much

 

[mwaltd]

My arb measures 64.5". I think its meant to be

 

[yugo308guy]

Nah....I don't think it will fit. You should just send it to me so I can scrap it for you! ; )

 

[mwaltd]

Well........ if you think that's what's best lol.

I really hope my truck sales soon. Have found a 89 raider v6 auto 90k miles. Headlight squirters on 33s fairly close hoping to scoop it up

 

[yugo308guy]

Good luck!