Squall Line
Observer
I am working on a friends '99 Tacoma prerunner... We are looking to run something along the lines of a Maxxis Bighorn in the 32x11.5x15 size, and wanted to check if there would be issues with rubbing at a 3" lift height (toytech kit). I would ask/ search on a Tacoma specific board, but I am not a member of any (I drive a Nissan...). I was mainly curious if these would rub the frame at stock offset, and if the 3" will be enough to clear the rear of the fender wheel under compression while turning. I just don't want to steer her in the wrong direction. Also, is it ill advised to run a tire of that width on the stock wheels?
Thanks for the help,
Thanks for the help,