3rd gen 4runner sway bar bushing replacements?

[JasonRedwood]

Theres the Energy Suspension kit
Prothane 181115 Front Sway Bar and Endlink Bushings - 26mm Made by Prothane
http://www.energysuspensionparts.com/proddetail.asp?prod=181115

I found these greasable sway bar bushings, but where do I buy the end link bushing separate? I think I would rather go greasable from past experience with my 1st gen.
http://www.summitracing.com/parts/ens-9-5161g/overview/

Any recommendations from experience.

Thanks,
Jason

 

[p nut]

Not sure on the ones you linked, but when I changed bushings, I went with Wheeler's.

http://wheelersoffroad.com/product/...shings-suspension-437513/front-anti-sway-kit/

 

[JasonRedwood]

Not sure on the ones you linked, but when I changed bushings, I went with Wheeler's.

http://wheelersoffroad.com/product/...shings-suspension-437513/front-anti-sway-kit/

Hey P nut, I assume you are happy with them. No squeaks or nothin? Asking because when I installed new A-arm bushings on my 1st gen they squeaked like mad.

 

[AxleIke]

Interested to hear about that too P_nut. I've had bad luck with polyurethane before, except for the the steering rack.

 

[p nut]

Hey guys, sorry, can't answer on a long-term test, but I had it 1.5 years after install (then sold) and didn't notice any squeaks. I did liberally apply the grease included. I will say that I didn't notice that much better feel when compared to new OEM rubber bushings. If you are concerned about potential squeaks, I would go OEM. That's what I did on my LC.

 

[JasonRedwood]

Thanks P nut. I think I am going to go OEM