Borrego60
Rendezvous Conspiracy
Well after 2.5 weeks off my feet from knee surgery it was time to install the heat exchange I recevied from Cruiser out fitters,Thanks Kurt. I went with 2 3" quickfists bolted to the fire wall,these things are there to stay. I had to cut the quick fist so it would be lower and not interfear with my hood closing. You can see the notch. The quickfists give some vibration protection and a cushion from wash board roads. The plan is to plum this inline with a Danfoss thermomixing valve so water temp is at a constant temp. I have not run the water line as of yet, I want to run to both ends of the tundra so I do not have to unhook the trailer where my water supply is. Also so I can pull water from other sources front or back. This is just the exchanger install for now and this thing cooks! Note I installed it right after the heater valve so I my control water temp better.