montero98ls
Observer
So first off let me say I only have a 1" body lift and never had problems till recently when I replaced my motor mounts. Everything was fine on and off road, but just the other day I took it out on some trails for the first time since I replaced the motor mounts. What I found out was when I hit a good bump or on a section where I am really flexing that the fan starts clipping the shroud. Assuming the bottom.
I noticed right away when I replaced my motor mounts that the engine Sat a bit higher. Not sure if because it is new and not compressed like the old one. So what I am thinking of doing is making a radiator drop bracket similar to the 4crawler one.. Before I do spend time on that I wanted to know if anybody else has any ideas or has something similar happen replacing motor mounts, also the previous owner did not have a shroud on. I went out and got one so I dont want to remove it especially since I live in the hotter part of so cal and frequent the desert quite often.
I noticed right away when I replaced my motor mounts that the engine Sat a bit higher. Not sure if because it is new and not compressed like the old one. So what I am thinking of doing is making a radiator drop bracket similar to the 4crawler one.. Before I do spend time on that I wanted to know if anybody else has any ideas or has something similar happen replacing motor mounts, also the previous owner did not have a shroud on. I went out and got one so I dont want to remove it especially since I live in the hotter part of so cal and frequent the desert quite often.
