Build Thread- 2003 Red Cross ERV- Rambolance

[carnut1969]

I installed a Nautilus door for space savings.
The bed/ bunk is mostly done also I incorporated a different approach with one of my cabinets:

 

[carnut1969]

 

[carnut1969]

Installed that swivel seat on the pass side (yes, rear seats are from a transit)

 

[carnut1969]

Here are a couple more interior shots. Still need to run the propane and water lines, build the kitchen and finish cabinets.

 

[carnut1969]

Up on the roof I added a deck and swapped the ac for a lower profile unit.
The water tank is in, propane tank installed, and I had the good folks at Atlanta Auto Diesel replace the whole fuel system.

 

[carnut1969]

Drive it to Florida and towed for the 1st time- tows GREAT. Took the LJ to the paint shop.

 

[motofreak0592]

Did you build that sliding cabinet yourself? Thats so cool! What did they do to your fuel system? Ive been thinking of doing a fuel bowl delete and an electric fuel pump for mine

 

[carnut1969]

Thanks! My buddy came up with the original idea and I had Technocraft make the cabinet and sourced the slides/ installed everything. Works perfectly.

Apparently there was a coating inside the tank from years of sitting. It was getting somehow sucked into the fuel system and causing blockages. We dropped the tank, had it blasted and re-coated then replaced the lines and pump.

 

[carnut1969]

Cabinets are done…

 

[carnut1969]

 

[carnut1969]

 

[carnut1969]

 

[carnut1969]

 

[carnut1969]

 

[john difool]

Worked on the van all weekend. Put the trim back on the van- paint came out great. Stripped the rest of the interior and found some really bad wiring work (so many of you have gorgeous wiring... not this one). I even found a 110V wire that had just been cut and left that way... no cap or anything. Its also a big mess of wires under the driver's seat- pics below tell the story. as a result, I'm going to go through all the wiring and get rid of whats not needed.

View attachment 595081


View attachment 595082


View attachment 595083


View attachment 595084

I acquired the exact same rig recently. How did you go about removing the wiring from the box? Trace everything, then cut?