Crazy Schooner
Fortune's A Mistress
Rack is a few years old. I wanted to run it across my bed, but it's too narrow for my truck box. it's just narrow enough that when I tighten everything down, it sucks in my bedsides and I can't close my tailgate. Previously I shortened it down and had it mounted on my older bed rack, and it worked fine. My new bed rack is longer. So the shorter length is not long enough for the new rack, and when the full tray is put back together, it's too long for my bed!
This is the rack I have.
https://www.frontrunneroutfitters.c...w-table-opening-front-runner-slimline-ii.html
Consisting of:
1 x FALD003 - Discovery Full Rack Foot Rail MKII 72.5mm
1 x RRSTD11 - Slimline II Tray - 1255mm(W) x 2166mm(L) x 50mm(H)
So I'm looking to sell it. You getting the full package (minus a couple load bars that I'm using to mount my RTT on my all-pro bed rack). I shortened it down temporarily to around 57" long , but it's back to being 85" long. Like I mentioned earlier, it's a few years old, so the aluminum in spots has oxidized and the powder coating is coming off (mostly the corner pieces). I drilled out (2) rivnuts on (2) of the corner pieces, as the they wouldn't take a bolt anymore. So I put in a small bolt/nylon nut combo to secure them in place. I have the wind fairing and bottle opener as well. The wind fairing is not installed as i'm short (3) M8 half nuts to lock it in place.
$800 obo. located in Edmonton, Alberta. I can possibly meet halfway somewhere in Alberta if you toss in some gas money.
This is the rack I have.
https://www.frontrunneroutfitters.c...w-table-opening-front-runner-slimline-ii.html
Consisting of:
1 x FALD003 - Discovery Full Rack Foot Rail MKII 72.5mm
1 x RRSTD11 - Slimline II Tray - 1255mm(W) x 2166mm(L) x 50mm(H)
So I'm looking to sell it. You getting the full package (minus a couple load bars that I'm using to mount my RTT on my all-pro bed rack). I shortened it down temporarily to around 57" long , but it's back to being 85" long. Like I mentioned earlier, it's a few years old, so the aluminum in spots has oxidized and the powder coating is coming off (mostly the corner pieces). I drilled out (2) rivnuts on (2) of the corner pieces, as the they wouldn't take a bolt anymore. So I put in a small bolt/nylon nut combo to secure them in place. I have the wind fairing and bottle opener as well. The wind fairing is not installed as i'm short (3) M8 half nuts to lock it in place.
$800 obo. located in Edmonton, Alberta. I can possibly meet halfway somewhere in Alberta if you toss in some gas money.