Gen 3.5 front fender removal for antenna repair

[Offroadmuch]

So I found the three screws just inside the hood for the feneder. Can someone point out the location of ghe others? I need to pull the motorized antenna assembly. Thanks for the help....
I am going to try this in the FSM although it is kind of slow going to find things in there sometimes.

 

[clmrt]

Is it not done by pulling the wheel and fender liner? I have to do this too...

 

[coffeegoat]

It's on my list too, apparently just replacing the extendable mast is very easy generally with no part removal required, however, I'd rather go back with a flexible whip so it doesn't break again

 

[Michael Brown]

Remove the wheel and inner fender liner. I did this 2 years ago when I broke the original in an ice storm (low hanging tree branches).
The power unit can be split open after removing the housing screws.

I had found an instruction with pictures before, but cannot find it now.

 

[nwoods]

There are also a few bolts in the door jamb of the A piller (typically, not 100% sure about 3rd gen)

 

[Offroadmuch]

Thanks to all. I will try that in a few days and post some pics.

 

[Rod]

I did it by pulling fender liner underneath on top of tire.......

 

[Fergie]

I came at it from underneath as well.

I disconnected the power, and essentially have a fixed antenna now...easily reversible.

 

[Offroadmuch]

Picture from the Mitsu FSM on how to remove a front fender. Finally found this. Just FYI in case anyone else needs this reference.