I had the trailer serviced at Parker Trailers (inspection/bearing pack) in early December and then built the container out of pine and cedar panels, sealed with DAP dynaflex 800. The trailer tows fine and we put a little over 2000 miles on it with two different loads. Wheels and bearings were cold at every check.
7-pin trailer plug
Cargo area is 70½" Long by 41" between the frame, 48" between the walls
Several internal tie downs
Rubbermaid 50 gal tote an retainer bar included
Whole trailer tongue to tail is 133½" long by 86" wide by just under 50" high
Double hasp locks/door closure
Double header at front of cargo area
Genuine Jeep™ Taillights and LED markers
Coupler for 2" Ball
Cargo rings on top for Expandable Roof Top Bag (ROLA 59100)
I'm putting it up for $600 because it will go on cl shortly, but I'm willing to deal with forum members and will throw in the used airbags I was originally going to use for the AT build. The ROLA rooftop bag is also available.
7-pin trailer plug
Cargo area is 70½" Long by 41" between the frame, 48" between the walls
Several internal tie downs
Rubbermaid 50 gal tote an retainer bar included
Whole trailer tongue to tail is 133½" long by 86" wide by just under 50" high
Double hasp locks/door closure
Double header at front of cargo area
Genuine Jeep™ Taillights and LED markers
Coupler for 2" Ball
Cargo rings on top for Expandable Roof Top Bag (ROLA 59100)
I'm putting it up for $600 because it will go on cl shortly, but I'm willing to deal with forum members and will throw in the used airbags I was originally going to use for the AT build. The ROLA rooftop bag is also available.
