NMO mount for ARB bullbar

[Owyhee]

Can anyone suggest an NMO mount that will feed through the hole on the upper Tabs of an ARB bullbar. It's the winch bar for a 1996 FJ80 Land Cruiser.

73 KJ7PVH

 

[Owyhee]

I think this may work I need to check the thickness, as this one is only good out to 1/8" and I may have to bore out the opening to accommodate 3/4".

NMOHPCNRPSMM518: 3/4 Thru-Hole High Frequency NMO Mount with 17 Ft. ATX195 Cable & RP-SMA Male Connector Installed

This TE Connectivity Antenex 3/4 Thru-Hole NMO Mount is optimized for vehicular roof mounting of an NMO type antenna. Typically used with VHF or UHF or high-frequency (900 mhz+) antennas, the NMOHPCNRPSMM518 includes a 17 Ft. ATX195 Cable and RP-SMA Male Connector Installed If this is not the...

www.arcantenna.com

My intent is to run signalstuff's new automotive antenna.

https://signalstuff.com/products/nmo-quarter/

signalstuff.com

 

[dstock]

I think this may work I need to check the thickness, as this one is only good out to 1/8" and I may have to bore out the opening to accommodate 3/4".

NMOHPCNRPSMM518: 3/4 Thru-Hole High Frequency NMO Mount with 17 Ft. ATX195 Cable & RP-SMA Male Connector Installed

This TE Connectivity Antenex 3/4 Thru-Hole NMO Mount is optimized for vehicular roof mounting of an NMO type antenna. Typically used with VHF or UHF or high-frequency (900 mhz+) antennas, the NMOHPCNRPSMM518 includes a 17 Ft. ATX195 Cable and RP-SMA Male Connector Installed If this is not the...

www.arcantenna.com

My intent is to run signalstuff's new automotive antenna.

https://signalstuff.com/products/nmo-quarter/

signalstuff.com

There's an NMO thick plate mount that's also the correct diameter so you dont have to drill your bumper. I have 3 of them. Let me find you a link.

Sent from my Pixel 3 XL using Tapatalk

 

[dstock]

Double check your bumper hole size, this works with 3/8" to 3/4" holes and up to 1/4" think plates.

https://www.tessco.com/product/0-1000-mhz-thick-plate-mount-brass-no-connector-581052

 

[Hillbilly Heaven]

Yeah I 2nd the Tessco mount. You may find your mounting hole closer to 3/8 than 3/4 and material is probably 3/16 thick.

 

[BigSwede]

I don't think the tabs are 3/16 thick, if it is anything like the ARB bullbar I had on my old Trooper. The hole will be too small for standard NMO mounts but maybe those linked above will work.