PNWINFERNOPRO
@PNWINFERNOPRO
SOLD. THANKS
Selling a set of rear axle shafts from my JK Rubicon. The shafts and splines are straight. These are full set, ready to bolt in.
The passenger side shaft will need 2 of the retaining plate studs tack-welded, or a $10 new retaining plate pressed on. 2 of the studs were overtorqued from the factory, and are spinning in the plate. Not a big issue.
Located in Kirkland, WA
$200 shipped to the lower 48
Thanks
Selling a set of rear axle shafts from my JK Rubicon. The shafts and splines are straight. These are full set, ready to bolt in.
The passenger side shaft will need 2 of the retaining plate studs tack-welded, or a $10 new retaining plate pressed on. 2 of the studs were overtorqued from the factory, and are spinning in the plate. Not a big issue.
Located in Kirkland, WA
$200 shipped to the lower 48
Thanks
Last edited: