Poly Performance Jeep JK Synergy Suspension System 3” ?

[French JK Rubicon]

Hello every body !
good web site !
some body have a JK unlimited with a
Poly Performance Jeep JK Synergy Suspension System 3” ?[/EMAIL]
From a french Rubicon JK and Toyota also....
http://www.africatracks.com
http://www.egal16.com//preparations?fold=103

Best regards
/Users/admin/Desktop/JK-3PG.jpg
/Users/admin/Desktop/JK-4PG.jpg
/Users/admin/Desktop/JK-1PG.jpg
/Users/admin/Desktop/JK-2PG.jpg

 

[Gear]

Good morning Patrick,
I went out to the Jeep and checked, I have the same springs as you. 8063-30 front spring - 8064-30 rear spring. If the lift kit was just installed give it a couple of months to settle. When I first installed mine it was the same way, Very Tall. I thought Poly Performance may have given me the 4.5" lift springs. Over time the Jeep has lowered about 1-2 inches overall. I measured the wheel well locations on your drawings on my Jeep. Here are the measurements. Front tire(Goodyear MTR 315/75/16) to the lowest slightly inside lip of the fender. That measurement was 6.25 inches. The rear same location top of the tire to the lowest slightly inside lip of fender - 6.75 inches. I have some weight on the Jeep. In the rear I have a Jeeperman rear bumper with tire. On the front I have a Shrockworks bumper and a 9.5ti Warn Winch. So this could be part of my settling. Let me know if you need anymore measurements.

Oh and that is a beautiful build on your Toyota. Welcome to Expo.:wavey: