Fenderfour's latest activity
-
Fenderfour reacted to Alphamacaroon's post in the thread Alu-Cab ModCAP Hard-sided Popup Build with
Like.
The gussets arrived today from SendCutSend. Must say they did a great job! They are quite large, but like I said in a previous post... -
Fenderfour replied to the thread Toyota Town Ace 4WD Diesel Campervan Slider - $19,500 on Craigslist.with the 2 liter 2C engine, the zero to sixty time on this is "Maybe"
-
Fenderfour replied to the thread Alu-Cab ModCAP Hard-sided Popup Build.I'm with you, I suspect they will do a fine job of stabilizing the overhang. The significant increase in cross section will do that...
-
Fenderfour replied to the thread 1993 HiAce Firetruck Build Thread.I sorted out the issue with the 12VDC mains panel. Each switch has a three pins: source, load, ground. The ground pin is to operate a...
-
Fenderfour replied to the thread 1993 HiAce Firetruck Build Thread.More (modest) progress! Got the counter top attached. I hoped to get a slab of bamboo plywood for a counter, but no one near me has...
-
-
Fenderfour replied to the thread Alu-Cab ModCAP Hard-sided Popup Build.The low-profile L extrusions tend to be a little flexy. Have you done any deflection calculations on the cantilevered bed section...
-
Fenderfour replied to the thread 1993 HiAce Firetruck Build Thread.I'm beginning to think the 3L is lower power than the 2L in spite of more displacement. I have friend who has a 3L in a van and it's...
-
Fenderfour replied to the thread 1993 HiAce Firetruck Build Thread.spent a bunch of time getting electrical installed last week. It feels like this shouldn't take very long, but then you get started...
-
-
Fenderfour replied to the thread 1993 HiAce Firetruck Build Thread.Top speed is 70 ish. Going up hill requires a down shift to 4th with the weight of the camper back there. Before I added all that...
-
Here's a link to a copy on a google drive. NF 1192
-
Fenderfour replied to the thread Propane Basics For Build.There are standards. You have to buy them from RVIA. Surprisingly inexpensive, about $250 for the full set
-
Fenderfour reacted to Alphamacaroon's post in the thread Alu-Cab ModCAP Hard-sided Popup Build with Like.
Phase 1: Alu-Cab ModCAP Install One of the other reasons I opted for the ModCAP was its lead-time— being measured in weeks, not months...
-
Fenderfour replied to the thread Truck Camper Aluminium Frame.Welding aluminum does weaken it, but usually not enough to matter. It locally removes the heat-treatment, which does provide a lot of...
-
Fenderfour replied to the thread Propane Basics For Build.A full propane can is around 300 psi. The regulator pulls it down to 2-3psi (low pressure) or 7-10 psi (high pressure). Low pressure is...
-
Fenderfour replied to the thread Isolated Habitat Box Grounding Question.It doesn't. The tail lights are on the rear bumper. It's not long enough to need side marker lights. But, I may add some and this is a...
