Hey Ronin, haven't been on Expo much lately, just look'n at what been happening, came across your build and am very Impressed, My rig is a '10 Access Cab, good for the single guy but again very impressed with your rig ~ you've given me more ideas . . . Thanks Scott
PS: Where's Tahuya State...
As a Transplant from that little town south of Coeur D' Alene, ID, they called it LA, I have been working Wildland Fire since 1988 in Northern Idaho and I would recommend following the "1910 Fire History" the Palous, St. Maries, St. Joe through Avery the valley of "Ghost Cedar Trees" it will...
Hi Guys,
Just my .02, but living in Northern Idaho, I have been running KM2 235/85/16 from Tire Rack on a stock 2010 Toyota Steelie for the past 2yrs, from Mud up to the axle to 3+ feet of snow and the trick / advice is learn to air them down, my normal psi is 38/40psi Hwy and 20/9psi off road...
Know the name, but can't place the face. I'm not familiar with what lights you used for the ground lights, but 20" ? bar is amazing
Thanks again
Scott
ps: I'm looking at early retirement . . . by 2 years HUMMMMM What to do
You used Baja Design lights, over Light Force or others, how did you come to choose Baja Design . . . .
But I am very impressed with the light output in the photos
Thanks Scott
Welcome to the Toyota world, Mine was a 1987 and I put 380,000 miles before having to rebuild, now a couple of Mexican gardeners have it and I'm sure it's still going. I built it stock for the baja races and well the rest is history, "and history you will make, young jedi" Yota voice . . . . lol
Well I'm back and here is what I have learned: READ ALL INSTRUCTIONS !!!
With that being said, Thank you to all that have responded, and to those that I have called (ARB),
In the front page there is a chart that states; In the instructions for the ARB Bumper 3423130, ARB Combo Bull Bar with...
I don't have the set up sheets with me I'll have to double check, but I do recall it just had a chart with the bolt sizes and what the torque is for each bolt, I'll check and get back on this.
Thanks guys for your help and input
Well as with Oliverlove, I too did a ARB install only with a 2010 Access Cab, everything went as expected, well almost except when placing the outer support bracket and I went to crank in the recommended touqure at 57lbs to the bolt that went through the main frame it started to crush the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.