Recent content by g_hayduke

I actually built a system that uses a PearlAqua device as the final UV stage. The PearlAqua unit requires a 0.5 micron pre-filter per specification. And the unit I have is the largest 12V unit they had when I built it a year or so ago. And for the UV device to meet the ANSI spec for water from...

I use 2 of these in series. Maximum flexibility. Can run 1 or both together, depending on circumstances. They also make a 200W panel but I prefer 2 smaller panels for ease of handling and smaller footprint, less susceptible to getting blown over when not laying flat on the ground...

What does it weigh?

Any idea what it weighs? Do you have a title for it?

Do you have a title for it?

I'm liking the looks of the CPC Colder LC series but the only sources I've found require larger quantities than I need. Do you know a good source for individual Colder fittings?

I'm reviving this thread since I am getting ready to construct a portable filtration/purification system. I'll probably go with 2 10" Pentek housings and 1 of the PearlAqua Micro units along with a pump and quick disconnect fittings. Any good suggestions for the quick disconnects?

What is the curb weight and what is the GVWR?

If you want brakes, you'll probably need >= 3,000lb axle. I have a California Teardrops Krawler teardrop. The GVWR is <2500lbs but it has a 3500lb Dexter axle with electric brakes.

Fortunately for me, I am the lucky new owner of Mike's trailer. I actually never saw the ad here for some reason but it was here all along. I didn't start seriously looking until maybe 4 weeks ago and found this on the Phoenix CL and bought it last week. I am going over everything now and...

Is there room to sleep inside? One pic looks it shows a mattress in there. In any case, how about some interior pics?

Is that fully loaded (GVWR)? Or empty/unloaded? I'm near Albuquerque so not too far from you.