gator70's latest activity
-
Ggator70 replied to the thread Isuzu npr 4wd.Thanks for the comment I'm curious where the comment "twists the most" comes from. I see frame twist from engine mount to rear axle...
-
Ggator70 replied to the thread Isuzu npr 4wd.The red arrow points to a separation of plates I found grade 8 washers bonded with rubber. I think each bolt should have two inserted...
-
-
Ggator70 replied to the thread Isuzu npr 4wd.Thanks for the comment. The technical diagram of our subframe does not match the final product. It was a starting point. The "x" as...
-
-
GRespectfully, you seem rather intent on not letting him "do" him. Whatever sort of thread this might be, it's his, and nobody's being...
-
Ggator70 replied to the thread Isuzu npr 4wd.Re Frame twist I wonder if I'm doing enough? ++++++++++++++++ My current engineering provides for subframe frame separation My...
-
-
Ggator70 replied to the thread Isuzu npr 4wd.You are welcome to stop reading and commenting on the material, since it bothers you.
-
GIn my opinion, that St. Andrew's cross should be placed as close as possible to the cabin, which is where the inertia is strongest or...
-
Ggator70 reacted to JohnRogers's post in the thread 2011-2015 Canter/Fuso dual range transfer case swap possible? with
Like.
Surely just mounting up an atlas in the usa would be a simple exercise -
Ggator70 replied to the thread Isuzu npr 4wd.When using 12 gauge steel angle, say 4 inch by 1.5 inch. Then creating a picture frame design. Taking the frame and the truck to a body...
-
-
Ggator70 replied to the thread Isuzu npr 4wd.Hmm, seems like a build thread to me
-
Ggator70 replied to the thread Isuzu npr 4wd.The method to attach the subframe to the truck will be very close to this (using our spring plates)
-
-
Ggator70 replied to the thread Isuzu npr 4wd.I've posted this subframe picture before. We have since added a few more inner crossmembers. And on the main four corners, welded in 4...
-
-
Ggator70 replied to the thread Isuzu npr 4wd.Do I sense complaints?
-
Ggator70 replied to the thread Isuzu npr 4wd.This picture is a frame (seen from the bottom) which is bolted to inner habitat bolt plates (NOT TO THE XPS COMPOSITE FLOOR - kind of...
-
-
Ggator70 replied to the thread Isuzu npr 4wd.Unlike many, our subframe is attached to the habitat with other frames. We had this engineered, either weld or bolt, so both options...
-
