Hey Brule.
Back on the subject of front-end sag;
It is normal for the torsion bar lift to lower a bit as time goes on, right? I know you asked if I had adjustment left but to be honest I'm not sure. When I looked at pictures of your truck it seemed perfectly even. The front end of mine is noticeably lower. If I'm able to crank them up a bit more, it would be ok, right?
I was reading some forums and it was mentioned that there are aftermarket CV joints that are made in a way which increases their strength. "They can withstand a greater angle." Are these a myth?
Also, someone said something about a "cut and weld" kind of thing to lessen the angle of the CV joint. Is that in any way possible?