Recent content by Hoologan

It looks like you can fit a moto in the garage, but maybe in reverse. Can you confirm?

Hey Trevor, I estimate it weighs about 2500 - 3000 lbs fully loaded, but that is a total guess.

Some more photos

Asking $12,000, but open to offers. This is an awesome and capable trailer. Selling because I'm going with a square drop. Located in Roseville, CA Includes the following: Smittybilt Overland XL Tent w/ memory foam mattress topper Smittybilt 8ft Awning Lock n’ Roll hitch (both trailer and...

Hi, where are you located?

Where are you located?

Brand new never installed. Going a different route and don't want to deal with freight back to the vendor. Local pickup in Sacramento/Roseville, CA area. $750

I have the lifted Tundra and it's still too low for the trailer so I built a drop tongue and use a 2" raised Lock N' Roll hitch Excuse the mess (I cleaned up last weekend) Here's how it sits hitched up (pre-Lock N' Roll).

I was wondering why two fridges until I got to the booze pics. ?

Awesome! I did Deadhorse from Sacramento and back on a motorcycle in 2014. Best trip by far!

Same here but I didn’t want to be the “well I’m an engineer” guy. But yeah, I agree. 10mm is way heavier than I assumed based on the pic (I assumed 3/8” with no frame of reference) but it’s not the plate I’d be worried about, it’s the moment on that single bolt and drop hitch. I would do as...

What’s the plate thickness? Good effort but I don’t know if I would trust that.

You will. :p

That's an awesome setup! Threw me off a bit with the California plate lol

25 1/4" to the lower inner edge of the tongue receiver.