Recent content by Johny5

I have tons of but finding them will take a while to find . Basicly I cut cross member flush to bottom of frame then plate them back in . I weld 4 stover nuts on the inside of the filler plates . Then I make matting plates that bolt on . Then some tube tying them together

Im hoping to do another run late summer early fall . I moved and am in the middle of building a new shop

Sorry.sold out check with me in a few months

Damn , never wanted to go to Meixco and defiantly don't want to go now, Sounds like a bad deal , hope things work out for you , soon

Sweet van ! thanks for shairing.

I have put a strap around the bumper right in the middle , there is a heathy round cross member right behind the bumper , the plastic under the bumper is pretty tough and should bend back. , stock bumper will be tricky to get anything solid to tow from , I built a bumper with a receiver hitch in...

Not sure where the dirt cheap vans are in Vancouver , although I'm only looking at 5.3 and 6.0 gm vans because I have a 4x4 conversion kit for them.

Im just using small angle brakets in a few spots with 3/4 inch screws into the floor and walls. No issue so far after a couple years and a bunch of off road miles.

Im pretty sure the seat back is going to buckel long before the seat base fails. These things are pretty beefy and weigh 32lbs

Crazy amount of work you have preformed to get this van running . Good on you . Hopfully its something easy. keep plugging away. You should be able to find a good deal of differnt size rubber tube from industreal suppliers like Greenline

My white paint is bad on the hood and one rear door . The rear door is getting worse daily . I talked to paint shop and they said they would need to take it down to bare metal and re prime& paint to fix it.

Mines like that too .I'm not worried about it.

Thanks I might do a run of frame brakets but not anytime soon.

I have a few left from this batch . You will need to grind off the rivits that hold your seat tracks to your seat base then its bolt on to my swivel

If it was local to me i would buy it . I prefer the sliding door too . You can get into the side door if somone is parked next to you . My van has 450 km and slider works great . Back barn doors stick