No not everything transfers from a 2wd to 4wd. He was talking about a lift for the 2wd. In case you arent aware (obviously you dont) a 2wd suspension is different than the 4wd. Not to mention he already stated he was planning to buy a 4wd. So why throw money away on something hes not planning to...
Why would you even consider spending $2600 on trying to make a 2004 2wd slightly offroad capable? You can buy a decent 4wd gmt400 or 800 tahoe for that or maybe a little more for a really nice one. Hell take the $2600 sell your 04 2wd and buy a really nice 4wd. Spending $2600 on your 2wd while...
Again what youre mounting it to is going to be the limiting factor. 96 f350 frame is what 3/16" steel? Again with any of those clevis's youll bend whatever its attached to before youll bend even the lighter duty one. With them only being roughly 6 inches long and sticking out through the bumper...
The bigger limiting factor is going to be the bumper unless where youre mounting it to is 1/2" steel. The bumper is going to bend or deform before the clevis will.
You do NOT need to have the front wheels moving to engage 4hi or 4lo. In the newer IFS GM 4wd systems the front hubs are always locked. The front wheels are seperated from the front driveshaft in the differential not in the hub. The wheel, hubs, and axle shafts are always engaged. When 4wd is...
I checked it with a guage on the low pressure side. Of course the compressor didnt kick on so Im not sure. My concern with that was if they had depressurized the system when working on it.
Thank you I will.
It was in december I doubt they will do anything about it. I will give them a call...
My gen3 monty shredded a timing belt this winter and I had to have a shop do the work. It doesnt get run much right now with the move and new baby so I didnt notice till now that the AC isnt working. Apparently the defrost uses it is as well because when you turn it to defrost the AC light...
Yes. It will be a direct bolt in. I did measurements in my LJY when looking at switching my 01s bench for a newer seats with the LATCH system for baby seats. Bench, buckets whatever the body mounts are all the same front and rear. The actual brackets are seat specific so make sure you unmount...
Why is it whenever I see the word "overlanding" I picture some skinny jean wearing, bad IPA swilling, twisted mustache, round glasses, flannel wearing, Wheres Waldo looking ************?
If you want to get technical everytime you drive anywhere in anything you are "overlanding". You are driving over...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.