Mekcanix's latest activity
-
Using some CAD to check clearances around the Rock Jock sway bar. Cardboard Aided Design. Looks like it clears the rear end and drive... -
Today sucked. Everything went wrong. Waiting for parts. My welding regulator broke. First world problems. Still blessed and hope you all...
-
This is the donor vehicle. Photo taken in the early 90's. Interestingly, I had shaved the door handles and put flush handles from...
-
Removing more from the frame. I took off the chevy body mounts on both sides. They are riveted on at the factory. I'm going to be...
-
I decided to go 8 lug. When I drove this chassis around it always had a leak on one side. I think I found the culprit. Someone beat the...
-
I'm not going to lie. I'm pretty proud of myself for getting the tank back in by myself. Only a couple small scratches and it went in...
-
Have they lost their minds? Must be made from billet Inconel or normalized meteor.
-
Regarding the 6 or 8 lug... you're this deep, I say go 8 lug because why not.
-
How many of you knew that rebuilding motor mounts was even a thing? I am kind of surprised at how nice this chassis really is. When I...
-
Yes. The chassis already has a 14 bolt in the rear and I have 8 lug hubs for the front Dana 44. I switched the front back to 6 lug, but...
-
Today I hit the tank with a wire wheel, then primed it and sprayed a good coat of the best paint I know of, STEEL-IT. That should be...
-
No response? Tough crowd. There was some really foul gas in the tank. I pumped most of it out and then noticed some crud floating in...
-
I'm at a crossroads and need everyone's help. I went down a 6 lug rabbit hole to run Toyota wheels, but they don't fit the 14 bolt hubs...
-
Merry Christmas to me! The plastic selector knobs on my 1979 factory hubs are turning into dust so I splurged.
-
Mounting and plumbing fuel delivery. The Blazer 31 gallon tank is set up for an external pump. The rear feed line goes into a fuel water...
