Recent content by Phessor

1) I went with the standard bed height, there are times I wished I had gone with the taller setup, but it is only me most of the time, so I leave the bed made and never had a need to fold it all up. 2) I went with white to match my truck, it has held up pretty good so far. But I am sure it...

Who makes the control panel in your rig?

Mine have held up just fine in the Arizona, NM and Utah heat.

Stopped off at OVRLND camper last week to upgrade my struts. Always a great bunch of people there, thank you for your assistance. Now for some 1st Gen love...

It was great meeting you, hope you had a safe trip.

Have you weighed your rig? Curious what it weighs fully built.

I added a Renogy Battery Shunt 300 to my campers electrical system today. Did I need it, I don't know. I still have another 130 watt solar panel to add to my camper as well. This will bring me up to 260 watts. Than I may add another 105 amp hour battery to the system. So far everything has been...

More from my Utah trip.

I took a trip last month to Utah, had a blast on the White Rim Trail.

What they said?!?!

Nice Tacoma!

I was looking at that one, but he doesn't make it in 4"

Interior shot of my ducting.

I didn't grab any interior shots of this project. I purchased the 4" deck plate off amazon, it did not come with screws or the tool to snug it shut. I purchased stainless steel screws, nuts and washers at a local hardware store, along with a 4.5 inch hole saw. I made a backing plate out of...

It isn't easy cutting holes in the side of an expensive camper. But I feel this is a better answer to my heater ducting solution.