Search results

Yes, ours did for the first few months until I realized it was from any Plastic or vinyl made in China, High VOC materials off gassing in the enclosed environment. Here in the desert the heat inside the enclosed camper gets so hot it was causing the materials to off-gas and the alarm to go off...

We use ADCO Designer series, UV Hydro Micro Trailer/R-Pod RV. Camping world has them, item #127397. Cost is around $293 and they adjust and fit great.

Yes, while hooked up to shore power, if you want to use the electrical outlets or charge the batteries, the inverter needs to be turned ON.

All our Toyotas. Tacoma, FJ, FJ Imogene poser rock Colorado.

Check here for replacement triangle roof latches: Check out their 200, 400, 500 and 700 series. one of them has to be an exact fit. They are located in Cincinnati OH. https://mrohardware.com/product/zinc-701l-locking-stamped-loop-end-adjustable-over-center-catch-with-holes/

Yes, the fridge blanket does work well. Finding it took a bit, the ICECO VL90 cover was always out of stock.

Death Valley camping last week at Panamint Springs before the storm.

The city water internal lines are in the left of your picture. They have the grey plastic Hex connections you can put a wrench on. No flood, I saw water dripping out of the front left of the camper on a dry day immediately after hooking up the hose to the city water connection. No damage.

Yep, happened to us. They used a section of tubing JUST a tad too short and with the smallest amount of water pressure filling it, it let loose. We just upgraded the clamp to a better one and jammed it back together and tightened it up REALLY tight. Hasn't come off since. And while you're in...

We've got a 101A3 (1996). I discarded the brake components years ago and now want to re-install them, What brake components are you using in yours? Or did you do away with them entirely?

Tows great. 2,400 mile 2 week road trip went off without a hitch.

Didn't find any squatches in Crater Lake either.

Gone Squatchin in Redwood State park.

You push the button on the Renogy panel if you are on shore power or generator and want to charge the batteries. Pushing the button turns on the inverter. If you are just running on battery power, do not push it.

We also ditched the McHitch and went to the DO35. Thanks for the info.

Do you happen to remember the height of the D13 Hitch when you leveled and measured it? We are installing the same WDH on our 2021 Tacoma Off-road. Much appreciated if you can remember. And how many washers did you end up with on the button. I currently have 6 on there but am still in the...

There should be a laser cut arrow in the 3 position valve handle. Pointing to rear (rear tank), pointing to front (front tank) positioned in middle (dual feed) both tanks will be used. Verify handle position and water usage by looking at corresponding tank level meter to see if the handle is...

If you leave the water tank valve position lever (under the mattress) in the middle position, it will feed/Fill from both front and rear tanks. It will gravity fill/bleed over to equalize both tank levels over time (in minutes). If you only want to use/Fill the front tank, position the feed...

Can you take a close up pic of your set-up and post it ? I'm looking at going with that config with our Tacoma and was wondering how it would be done. Thanks.

Your VIN is on the crossbar to the left of your jockey wheel. It will be facing backwards toward the tool box so it doesn't get destroyed by off road debris.