fsiegels727
Member
Hey folks, I have a pair of bed bars for sale that should fit on any 1st gen tundra. I am aware that there are not a lot of companies out there that make these so I had a buddy thats good with a welder make me this set.
I don't have exact measurements, but can get them if someone needs them. The bars have been bedlined. The holes for mounting a RTT are measured and drilled for a Tepui but the bars will work with clamps as well.
The construction is basic but solid...I could probably roll my truck onto them, and they are attached via truck bed shell clamps...I was planning on a more permanent solution but this worked so well I never hard mounted anything.
Height wise I designed them so that most clamshell RTTs will sit flush with the roof for better MPG and a clean look.
If you have any questions please give me a shout, I am located in Southern NH!
$300 OBO
for anyone curious...the rack is tall enough to fit two Predator PDL kayaks underneath it!
I don't have exact measurements, but can get them if someone needs them. The bars have been bedlined. The holes for mounting a RTT are measured and drilled for a Tepui but the bars will work with clamps as well.
The construction is basic but solid...I could probably roll my truck onto them, and they are attached via truck bed shell clamps...I was planning on a more permanent solution but this worked so well I never hard mounted anything.
Height wise I designed them so that most clamshell RTTs will sit flush with the roof for better MPG and a clean look.
If you have any questions please give me a shout, I am located in Southern NH!
$300 OBO
for anyone curious...the rack is tall enough to fit two Predator PDL kayaks underneath it!
