BorealOverland
Active member
So after building my kitchen module / slide platform i was looking for a way to get running water from
my 13L jerrycan that i bought because it fits perfectly on the slide next to the kitchen module..
Many of you might have seen or used these little 5V USB pumps,
but i just recently discovered them after a tip from @plh in another tread, thanks again.
I don't know how long these little suckers last so i ordered an extra jerrycan cap with spout just as backup.
So far it runs quiet and has a good flow rate.
A micro DIY job, drill hole in the jerrycan cap, screw in a cable gland, push pump snug into rubber in cable gland, tighten gland, done.
Cheers!
Steve.
Link to Kitchen Platform build:
(https://expeditionportal.com/forum/...for-my-8020-kitchen-module-photoheavy.224090/ )
my 13L jerrycan that i bought because it fits perfectly on the slide next to the kitchen module..
Many of you might have seen or used these little 5V USB pumps,
but i just recently discovered them after a tip from @plh in another tread, thanks again.
I don't know how long these little suckers last so i ordered an extra jerrycan cap with spout just as backup.
So far it runs quiet and has a good flow rate.
A micro DIY job, drill hole in the jerrycan cap, screw in a cable gland, push pump snug into rubber in cable gland, tighten gland, done.
Cheers!
Steve.
Link to Kitchen Platform build:
(https://expeditionportal.com/forum/...for-my-8020-kitchen-module-photoheavy.224090/ )