Connecting up 2 Dokio solar panels.

[dbhost]

So my solar setup at this point is as follows.

Dokio 300w folding portable solar panels x2 for a total of 600w. These output via SAE connectors. I have 2 SAE extensions and a Y cable, which then connects to the SAE port on the side of my camper shell, and then cabled down to the 40 amp solar charge controller / DC to DC charger.

And eventually out of the charge controller to the battery monitor and battery.

The in / out of the controller is via the MFGs recommendation, however I am not sure the panel configuration is correct.

 

[dbhost]

Never mind, I answered my own question. That would be parallel wiriing, so amperage goes up, which is what I want, voltage stays the same, which is fine...