LilKJ
Adventurer
It's a work in progress but here's what I have thus far...
It's made of some sheets of aluminum diamond plate I found at the scrap yard. It's slowly turned into this... It's not close to done yet and I think I need some suggestions on where to go with it.
The mockup...
Opened up... (the light was a tester and has since been replaced)
Bedlined the inside of the shelves and mounted the compressors and a locking safe...
I'm not sure if I should leave it how it is or where I should go with this.... any suggestions?
It's made of some sheets of aluminum diamond plate I found at the scrap yard. It's slowly turned into this... It's not close to done yet and I think I need some suggestions on where to go with it.
The mockup...
Opened up... (the light was a tester and has since been replaced)
Bedlined the inside of the shelves and mounted the compressors and a locking safe...
I'm not sure if I should leave it how it is or where I should go with this.... any suggestions?