Ford 350 airbag wire extension for swivel seat?

[Surffj62]

Did the passenger seat swivel - it's pretty cool. Problem is it takes a few steps to get the seat turned around and I am worried about busting the wires. I can't figure out how to make an extension between the factory plugs from bag to seat sensor if you want to call it that. I think I saw another thread here where someone made a pigtail wire one. Can't find it. Any info would be much appreciated. Thanks!

 

[Surffj62]

For clarification it's the wire that runs from the base of the seat and tells the airbag if the seat is occupied and at full "swivel" there is not enough length.

 

[Jsweezy]

On my van I just cut a hole in the fabric behind the rear swivel base plate and ran the cord up through there along the left side until it plugged in. Then whenever I swivel its able to follow along without any issues.

 

[Surffj62]

Cool- I will look at that.

 

[Abitibi]

Is that wire simply for the seatbelts pre-tensioners? Cause pretty sure there's one on the drivers seat

Sent from my SGP511 using Tapatalk