my new Comeup Seal Gen2 9.5s winch.

[paranoid56]

So i needed to replace my broken warn m8000 (think motor died) and after talking to the nice folks at Comeup winch at the off road expo the other week I decided to pick one up for my Tacoma with a ARB bumper.
So far i am super impressed with this winch.

out with the old, in with the new

few things i noticed
all the smaller connections are fully soldered.

the control box is all extruded aluminium. not cheap plastic. also uses a solid state relay, not the starter relay setup that my warn had.

all the large power wires came with nice adhesive lined heat shrink. another nice touch to make sure everything stays sealed.

and all installed

and spooled up with a new winch thimble.

so far its been great, will report back after some actual usage. but this one is much faster then the old and so much more beefier.

the only issues i ran into were i think this winch was a bit large to fit in the ARB bumper (but they did warn me that it might not fit) i had to persuade the tacomas lower sheet metal cross member to give more room. the other issue was that clocking it, took more effort then i would think. but after a bit i had it all setup.

 

[Box Rocket]

I think you'll love it. I have been extremely happy this same winch in my 80 Series LC.

 

[Snapdive]

Did it come with that mounting bracket?

I've been eyeing the comeup winches after my smittybilt died on me.

 

[paranoid56]

Did it come with that mounting bracket?

I've been eyeing the comeup winches after my smittybilt died on me.

which one? the one holding the solenoid? if so that came with the bumper

 

[Snapdive]

Yes, that one..

Thanks!

which one? the one holding the solenoid? if so that came with the bumper