WESBC
Observer
Selling my TRD Cold Air Intake that came off my 2007 FJ Cruiser. I believe it fits 2007-2009 FJ's.
I got this used a few years ago and decided to sell because I want a new knife (CRK small Insingo ) . I probably put 30K on it + whatever the previous owner did on it. This came off the 2005 prototype FJ that TLC 4x4 built up when they first came out (bought it in 2009). I'm pretty sure it was a show car that didn't see much action.
(Holes were drilled into the housing by the PO, I plugged and sealed them)
Note: Not all the hardware was included when I bought it, so I pulled some parts from my spares bin to make it work. The only thing you would need is the gasket for the MAF (I made one out of some thin rubber)
Here are the instructions http://www.trdsparks.com/install/PTR05-35061inst.pdf
Price: SOLD . Picked up in Walnut, CA (91789) or can be shipped at your cost.
The first one that puts the cash in my hand gets it.
For the quickest response, email me at:
I got this used a few years ago and decided to sell because I want a new knife (CRK small Insingo ) . I probably put 30K on it + whatever the previous owner did on it. This came off the 2005 prototype FJ that TLC 4x4 built up when they first came out (bought it in 2009). I'm pretty sure it was a show car that didn't see much action.
(Holes were drilled into the housing by the PO, I plugged and sealed them)
Note: Not all the hardware was included when I bought it, so I pulled some parts from my spares bin to make it work. The only thing you would need is the gasket for the MAF (I made one out of some thin rubber)
Here are the instructions http://www.trdsparks.com/install/PTR05-35061inst.pdf
Price: SOLD . Picked up in Walnut, CA (91789) or can be shipped at your cost.
The first one that puts the cash in my hand gets it.
For the quickest response, email me at:
Last edited: